Difference between revisions of "Dwell cam"

From WOI Encyclopedia Italia
Jump to navigation Jump to search
m
 
m
 
Line 11: Line 11:
  
  
{{mech-engineering-stub}}
+
{{Automobile configurations}}
 +
{{Piston engine configurations}}
 +
{{Machine configurations|state=uncollapsed}}
 +
 
  
  
 
[[Category:Mechanisms]]
 
[[Category:Mechanisms]]

Latest revision as of 20:47, 16 July 2008


A dwell cam is an intermittent motion mechanism that alternates forward and return motion with holding position.

Dwell cams are often used in pairs in sewing machines to operate the four motion feed dogs, with one cam moving the dog up and down, and the other cam moving the dog forwards and backwards. The cams in this application are usually phased 90 degrees apart allowing a pause in the up/down movement of the dog while it is being moved forwards/backwards. A separate adjustable sliding block or link is used to control the amount of forwards/backards movement of the dog.

See also


Piston engine configurations
Straight Single, 2, 3, 4, 5, 6, 8, 9, 10, 12, 14
V 2, 4, 5, 6, 8, 10, 12, 16, 20, 24
Flat 2, 4, 6, 8, 10, 12, 16, H
W 8, 9, 12, 16, 18
Other inline H, VR, Opposed, U (Square), X
Other Hemi, Radial, Rotary, Pistonless, Deltic, (Wankel)



Heat engines
Stroke cycles
OneTwoFourSix
Engine types
Gas turbinePistonJetRocket engineSteam engineStirling engineTschudiTwingle
RotaryWankelFree-pistonBritalusCoomberSwing-pistonOrbitalQuasiturbine
Valves
Cylinder head portingD slideFour-strokeManifoldMultiPistonPoppetSleeve
Piston layouts
Single cylinderStraightOpposedFlatVWHDelticRadialRocket engine nozzleRotaryStelzerControlled CombustionBourke
Motion mechanisms
CamConnecting rodCoomber rotaryCrankCrank substituteCrankshaftLinkages (EvansPeaucellier-LipkinSector straight-lineWatt) • Double acting/differential cylinder
Thermodynamic cycle