Search results

• Ablocco
  ...llowing for a reduction in the thickness of the tubes, and subsequently, a reduction in weight in the lower stress area. Ablocco has also made ergonomic advance
  1,015 bytes (152 words) - 22:57, 16 August 2008
• Cagiva C593
  ...titanium (thickness reduction) and carbon fiber silencers (which allowed a reduction of weight), the swingarm carbon fiber, also as with the previous model, thi
  2 KB (299 words) - 22:14, 28 January 2009
• Cagiva Gran Canyon
  ...e ag over the saddleback, with the modification of the lateral ags and the reduction of the tank, in fact the Elefant was a motion from street desert, while the
  756 bytes (123 words) - 15:20, 5 December 2007
• FART
  ...r. Versions were offered with two set of wheels per axle and an extra gear reduction, enabling it to crawl up a 40 per cent gradient and achieve a top speed of
  1 KB (174 words) - 00:13, 28 July 2009
• Cagiva Grand Canyon
  ...e as well as editing [[motovaligia | bags side]]. Furthermore, there was a reduction in the capacity of the tank, the Elefant was a motion by [[desert]] "road,
  2 KB (225 words) - 23:17, 28 January 2009
• Engine knocking
  * Reduction of cylinder pressure by increasing the engine revolutions or reducing the l ...in-cylinder temperatures (such as through cooling or [[compression ratio]] reduction).
  4 KB (649 words) - 08:51, 8 October 2009
• UnoAErre
  It began a reduction of its workforce in the early 70. Today employees are under 500 units. The
  2 KB (314 words) - 06:36, 13 August 2009
• Menon
  ...ne by pulleys, as was usual for a belt drive, it used a drum with a single reduction gear. Maximum speed was a respectable 25 mph. Menon, a few years later, off
  1 KB (205 words) - 23:57, 1 November 2010
• Swing axle
  # Reduction in cornering forces due to change in camber can lead to oversteer instabili
  2 KB (318 words) - 21:51, 17 August 2009
• Launch control
  ...e allowed again, but as of [[2005]] it is forbidden for the sake of budget reduction of F1 teams.
  2 KB (390 words) - 23:31, 3 February 2009
• Sway bar
  The first is the reduction of body lean. The reduction of body lean is dependent on the total roll stiffness of the vehicle. Incr
  5 KB (793 words) - 09:26, 7 October 2009
• Grand Prix motorcycle racing
  ...GP class machines will be restricted to 800 cc. The stated reason for this reduction is to improve rider safety, as the power output and top speed of MotoGP mac ...redesign their engines. Cynical journalists have suggested that this power reduction decision came about due to pressure from Honda, but there is no public evid
  8 KB (1,206 words) - 08:06, 8 October 2009
• Automobile emissions control
  ...al increases in the number of vehicles in use, have meant that the overall reduction in pollution has been much slower. Significant reduction of emissions come from
  10 KB (1,533 words) - 09:02, 8 October 2009
• Automobile self starter
  Chrysler manufactured a gear reduction starter employing a small gear to drive a larger gear attached to the start ...r released from the tank is used to spin the turbine, and through a set of reduction [[gear | gears]], engages the ring gear on the flywheel, much like an elect
  7 KB (1,049 words) - 22:37, 23 September 2009
• De Dion tube
  ...l, an integrated drive component consisting of an AC electrical motor, 3:1 reduction, and differential action was mounted to the chassis.
  3 KB (488 words) - 22:47, 23 September 2009
• Bugatti Model 100
  ...passed on either side of the pilot literally under the armpit and met at a reduction gearbox in the front of the craft.
  3 KB (475 words) - 11:02, 20 September 2009
• MacPherson strut
  ...s such as [[double wishbone]]s, requiring manufacturers to add extra noise reduction or cancellation and isolation mechanisms. Also, because of its greater size
  3 KB (550 words) - 23:01, 7 August 2009
• Air brake (rail)
  Unlike the straight air system, the Westinghouse system uses a ''reduction'' in air pressure in the train line to apply the brakes. When the engineer ...operations, the engineer makes a "service application" or a "service rate reduction”, which means that the train line pressure reduces at a controlled rate.
  20 KB (3,254 words) - 23:06, 5 July 2009
• Spaghetti Bolognese
  * Add a half-glass of [[white wine]] and let it [[Reduction (cooking|reduce]].
  4 KB (564 words) - 22:52, 17 September 2009
• De Tomaso Pantera
  ...amshaft timing (in an effort to reclaim some of the power lost through the reduction in compression). Many other engine changes were made, including the use of
  4 KB (664 words) - 10:13, 26 May 2009
• Bandini 1300
  ...nels in aluminium fixed to the frame through rivets. This allows a further reduction of weight that can be used as ballast.
  4 KB (499 words) - 22:31, 23 September 2009
• Custom wheel
  ...[[drag racing]], the forces on the wheel are somewhat different and weight reduction is balanced primarily against the traction benefits of a wider tire on the
  3 KB (466 words) - 22:52, 14 April 2010
• Variomatic
  ...conical drums in both pulleys, the diameters and so also the [[gear ratio|reduction ratio]] changes continuously.
  5 KB (710 words) - 23:28, 3 July 2009
• Lancia Dialfa-18HP
  ...]) to 4 relationship with command over reverse-stick side; final report of reduction (conical gears) 2722:1 (18/49)
  4 KB (489 words) - 20:23, 24 February 2009
• Gear ratio
  ...st gear the largest gear has only turned 0.62/2 = 0.31 revolution, a total reduction of around 1:3.
  6 KB (1,061 words) - 07:42, 9 August 2009
• Brake fade
  Vehicle [[Brake|braking system]] '''fade''', or '''brake fade''' is the reduction in stopping power that can occur after repeated application of the brakes, The reduction of friction termed brake fade is caused when the temperature reaches the "k
  10 KB (1,643 words) - 20:15, 20 August 2009
• Lancia Eta-30/50HP
  ...:1, 1550:1 at third, direct (1 : 1) in the fourth, reversing 3521:1; final reduction (bevel gears) 3600:1 (15/54), available also the following other reports 32
  4 KB (553 words) - 21:23, 27 April 2009
• Catalytic converter
  # [[reduction]] of [[nitrogen oxides]] to [[nitrogen]]: NO_x &rarr; O<sub>2</su ...uel than oxygen (stoichiometrically), then the engine is running rich. The reduction of NO_x is favoured.
  11 KB (1,638 words) - 08:05, 8 October 2009
• Benetton B195
  ...ed for the season including smaller wings, better crash protection and the reduction of engine size from 3.5 to 3.0 litres.
  7 KB (859 words) - 16:23, 24 February 2009
• Lancia Delta-20/30HP
  ...hird, taken manager (1:1) in fourth, 3,268:1 in reverse; final relation of reduction (bevel gears) 3,267:1 (15/49) or 3,0625:1 (16/49) or 3,600:1 (15/54)
  5 KB (711 words) - 21:16, 10 March 2009
• Risk compensation
  ...rs later. The law was duly passed and subsequent investigation showed some reduction in fatalities, the cause of which could not be conclusively stated, due to .../ip.bmjjournals.com/cgi/content/full/4/2/89] This was followed by a marked reduction in the traffic fatality rate, but the trend returned to its previous values
  8 KB (1,221 words) - 23:03, 15 November 2009
• Brake (railway)
  ...n each wagon that enable the brakes to be applied fully with only a slight reduction in air pressure, reducing the time that it takes to release the brakes as n
  4 KB (667 words) - 09:40, 8 October 2009
• Lancia Trikappa
  ...hird, taken manager (1:1) in fourth, 3,521:1 in reverse; final relation of reduction (bevel gears) 3,9167:1 (12/47)
  4 KB (552 words) - 15:32, 6 December 2010
• Autódromo José Carlos Pace
  ...uld fit the new FIA restrictions on track length). As a consequence of the reduction, the track lost three long straight sections and three fast curves (another
  7 KB (1,070 words) - 10:29, 15 July 2009
• Steering
  ...y do away with as many mechanical components (steering shaft, column, gear reduction mechanism, etc.) as possible. Completely replacing conventional steering sy · The absence of steering shaft, column and gear reduction mechanism allows much better space utilization in the engine compartment.
  12 KB (1,845 words) - 10:47, 8 October 2009
• Roadway noise
  ...wever, if the trend in [[hybrid vehicle]] use continues, substantial noise reduction will occur, especially in the regime of traffic flow below 35 miles per hou
  7 KB (1,112 words) - 22:47, 11 June 2009
• Ducati Monster
  ...me and aluminium brake disc carriers, which account for a 1&nbsp;kg weight reduction.
  5 KB (735 words) - 10:27, 26 October 2009
• Lamborghini Sesto Elemento
  ...y into its design language. A clear strength of the CFRP technology is the reduction and integration of components - something that has been used to its full ex ...ehind the front wheels. Sharply cut headlamp units complete the front end. Reduction is the name of the game here, too - alongside the bi-xenon lamps, there are
  20 KB (2,951 words) - 18:16, 12 November 2012
• Exhaust pipe
  ...of larger pipe than the rest of the exhaust system. This produces a final reduction in pressure, as well as prevents rusting of the tips, and can be used to en
  9 KB (1,513 words) - 10:12, 14 June 2009
• Hydraulic brake
  ...so cause permanent changes in the shape of the metal parts, resulting in a reduction in braking capability that is irreparable without complete replacement of t
  7 KB (1,200 words) - 09:40, 8 October 2009
• Future of Formula One
  While tyre rules usually are implemented primarily for safety and/or cost reduction, some detractors felt that this rule was an attempt to mix the grid up due * A reduction in testing to just ten days per season
  20 KB (3,254 words) - 08:04, 8 October 2009
• Menarini
  ...ents were introduced such as a better acoustic insulation, the curb weight reduction, the interchangeability of parts which can fail.
  7 KB (1,046 words) - 09:50, 14 September 2010
• Compression ratio
  ...on ratio would be proportionally described as 1000:100, or with fractional reduction, a 10:1 compression ratio. ...on for this difference is that compression ratio is defined via the volume reduction,
  16 KB (2,479 words) - 14:53, 25 September 2009
• Ferrari 360
  ...e '''360 Modena''' features styling by [[Pininfarina]], significant weight reduction, and an improved mid-mounted V8 engine; it is the first production Ferrari
  6 KB (804 words) - 10:35, 15 March 2010
• Fiat Cinquecento
  ...isplacement of this unit was limited to 899&nbsp;cc in 1993, with a slight reduction of output, now producing 39&nbsp;[[horsepower#PS|PS]] [[ECE]] (29&nbsp;kW).
  7 KB (1,015 words) - 17:50, 31 October 2009
• Seat belt
  ..., stemming from the observed fact that no country is able to demonstrate a reduction in road fatalities due to passage of a seat belt law, though deaths have in
  7 KB (1,222 words) - 10:44, 8 October 2009
• Aluminium
  ...acking of [[Alfred E. Hunt]] of [[Pittsburgh, PA]], started the Pittsburgh Reduction Company, renamed to Aluminum Company of America in 1907, later shortened to ...ced to the pure metal. By this process, the operational temperature of the reduction cells is around 950 to 980 °C. Cryolite is found as a mineral in Greenland
  35 KB (5,288 words) - 22:04, 13 July 2007

View (previous 50 | next 50) (20 | 50 | 100 | 250 | 500)