Search results

• Ducati 851
  ...they were only able to reduce the included valve angle of the desmodromic engine to 40°, while less than 30° was possible with valve springs. Ducati stuck *Engine type: L-twin
  3 KB (386 words) - 11:33, 14 June 2009
• Motauto
  ...nt of the engine by means of a chain. The suspension is telescopic and the engine is a single cylinder two-stroke 125 cc. The machine was ultimately, the int
  2 KB (262 words) - 08:30, 26 June 2010
• Ducati Supermono
  ...49/572&nbsp;cc 4-valve [[desmodromic valve|desmodromic]] [[single cylinder engine|single]]<br>12:1 [[compression ratio]]<br>Weber [[fuel injection]]<br>bore The '''Ducati Supermono''' is a lightweight, [[single cylinder engine|single-cylinder]] racing [[motorcycle]] made by [[Ducati]]. It is named for the [[Supermon
  4 KB (574 words) - 21:47, 9 November 2010
• Motopiana
  ...engine. In 1927 a model appeared with a 250 cc single cylinder side-valve engine.
  1 KB (176 words) - 11:30, 18 April 2010
• Napier Deltic
  ...er)|Delta]]) is used to refer to both the opposed-piston high-speed diesel engine designed and produced by [[Napier & Son|D Napier & Son]], and the locomotiv ...er_deltic_animation_large.gif|thumb|left|An animated schematic of a Deltic engine. The inlet is coloured green and the outlet purple. Notice the bottom shaft
  7 KB (1,154 words) - 23:48, 11 September 2009
• D & C
  ...using an old [[Faini]] engine. The engine, recovered in a warehouse, was a single-cylinder two-stroke 125 cc, Eisemann magneto, [[Longuemare]] [[carburetor]], [[two-s ...[[Della Ferrera]] two-stroke 125 cc, rounded cylinder, maxi power of 3 HP engine, [[two speed]] [[transmission]] with wide ratios and a maximum speed was 70
  2 KB (315 words) - 00:28, 6 February 2011
• Rotary engine
  ...es which do not use pistons, see [[pistonless rotary engine]] and [[Wankel engine]] ...arly type of [[internal-combustion engine|internal combustion]] [[aircraft engine]], used mostly in the years shortly before and during [[World War I]]. It
  12 KB (2,030 words) - 18:09, 14 September 2009
• Elmeca-Gilera
  ..., Gilera enters the world of off-road with a 50 cc and a 125 cc two-stroke engine. Despite the many successes, [[Piaggio]] blocks the production of a series ...dated with a much improved engine. The engine of the ''Regular 125'' was a single-cylinder two-stroke, air cooled that produced 23.5 hp at 10,000 rpm. The production
  2 KB (263 words) - 23:34, 18 December 2009
• Kram-It
  ...h a [[Minarelli]] 50 and 80 cc engine, and one with a 125 and 250 cc Rotax engine, plus a 300 cc normali version. The engines used were a single cylinder two
  1 KB (187 words) - 23:43, 17 December 2016
• Engine tuning
  ...ding''' is the adjustment, modification or design of [[internal combustion engine]]s to yield more performance, either in terms of power output or economy. I ...ks on all engines and the final but essential steps in setting up a racing engine. On modern engines some or all of these tasks are automated.
  9 KB (1,414 words) - 23:32, 3 July 2009
• Faini
  ...In 1923, they developed an auxiliary two stroke 98 cc engine and a 123 cc engine which became the hart of many mopeds, even a "for the ladies" model with op
  1 KB (157 words) - 10:05, 30 June 2009
• Pushrod engine
  ...n a [[straight engine]] or directly above the crankshaft in the V of a [[V engine]]. This contrasts with an [[overhead camshaft]] (OHC) design which places t ...displacement]]. In [[1949]], [[Oldsmobile]] introduced the [[Oldsmobile V8 engine|Rocket V8]]. It was the first high-compression cam-in-block design, and is
  10 KB (1,635 words) - 08:54, 4 August 2009
• Top dead center
  In a [[reciprocating engine]], the '''dead centre''' is the position of a piston in which it is farthes ...[flywheel]] to overcome the dead centre, or are designed, in the case of [[Engine configuration|multi-cylinder engines]], so that dead centres can never exis
  5 KB (842 words) - 21:57, 25 May 2010
• Bandini 1000 GT
  ...ed. The ''1000 GT'' preserves the traditional pattern which provides front engine and rear wheel drive. The chassis instead enjoy the experience made with th == The Engine Bandini 1000 cm ³ ==
  4 KB (501 words) - 22:28, 23 September 2009
• Barison & Co.
  ...C.)''. However, only a single car was designed and built with a 4-cylinder engine. By 1925, approximately 20 copies of that vehicle would be created but with
  1 KB (180 words) - 21:42, 18 April 2012
• Reciprocating engine
  ...Components of a typical, [[four stroke cycle]], internal combustion piston engine. <br> ...stay of the [[industrial revolution]] and the niche application [[Stirling engine]].
  9 KB (1,400 words) - 18:37, 9 August 2011
• V engine
  [[Image:Blumfield V-twin motorcycle engine.jpg|thumb|200px|right|An early Vee engine - this is a two-cylinder V-twin used in an early British motorcycle]] ...pes of engine: a&nbsp;— straight engine, b&nbsp;— Vee engine, c&nbsp;— VR6 engine]]
  3 KB (481 words) - 09:27, 10 November 2009
• Menon
  ...s a single model with De Dion-engine, front engine with a 1.25hp. The 3 hp engine was conventional, except for the fact that it was designed to run on an alc
  1 KB (205 words) - 23:57, 1 November 2010
• Ceccato
  ...roller on the rear wheel. In 1951, they also produced a bike with a 75 cc engine and in 1952, a two-stroke bike with 125 cc. ...four-stroke 75 cc, 98 cc and 125 cc various. These had a vertical cylinder engine, a distribution valve controlled by the head with tree cams in the head and
  3 KB (456 words) - 16:53, 30 November 2010

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)