Search results

Jump to navigation Jump to search
  • * [[Auxiliary power unit]]s
    2 KB (234 words) - 08:45, 15 June 2009
  • ...The fluids are found in machinery and equipment ranging from [[brake]]s, [[power steering]] systems, and [[transmission (mechanics)|transmissions]] to [[bac Environmentally sensitive applications (e.g. [[tractor#power and transmission|farm tractors]] and marine [[dredging]]) may benefit from
    6 KB (816 words) - 21:18, 12 February 2009
  • ...t coil springs and anti-roll bar; At the rear, trailing arms mounted on an auxiliary subframe, coil springs and an anti-roll bar. ...the 2.0 L, 5 cylinder 20V got a (Variable Inlet System) which brought the power to 154 bhp. The 2.0 L 5 cylinder 20V Turbo received a 6-speed gearbox and a
    7 KB (1,086 words) - 10:35, 2 November 2009
  • ...t coil springs and anti-roll bar; At the rear, trailing arms mounted on an auxiliary subframe, coil springs and an anti-roll bar. ...the 2.0 L, 5 cylinder 20V got a (Variable Inlet System) which brought the power to 154 bhp. The 2.0 L 5 cylinder 20V Turbo received a 6-speed gearbox and a
    7 KB (1,086 words) - 06:08, 26 September 2016
  • ...iprocating [[piston engine|pistons]]. This design promises smooth high-rpm power from a compact, lightweight engine; however Wankel engines are criticized f ...ar to the output of a [[two stroke cycle]] engine. Thus, [[Power (physics)|power]] output of a Wankel engine is generally higher than that of a four-stroke
    23 KB (3,604 words) - 09:49, 2 August 2009
  • ...vances. Powered by a 4 stroke ''under'' 125 cc engine developing a 8 Hp of power, it would be able to reach 100km/h. ...951]] they presented the "250 H", a utility with two stoke engine with low power relation to displacement. Followed in [[1953]] by the "Pole 125" model, a m
    12 KB (1,866 words) - 06:47, 4 December 2010
  • ...highest such rating assigned). The 3L80HD was introduced in 1987 as the HD unit used in passenger trucks. In 1992 a 4-speed overdrive version, the [[GM 4L8 ...lure in the THM200 were improved, and this transmission was used with high-power applications - primarily the Buick Grand National. GMs powered with the [[O
    14 KB (2,205 words) - 17:10, 11 May 2009
  • ...four silentbloc, to two small crossbows fixed members of the women's army auxiliary corps to the chassis. Other characteristic taken from the Dilambda is the c ...rn out you of the test: 70,86 the cronometrata maximum speed is of [[mile (unit of measure) |miglia]] to the hour (114 km. hour), [[the acceleration]] from
    37 KB (5,283 words) - 01:57, 12 December 2011
  • ...lsion]]. The HV pollutes less and uses less fuel. The different propulsion power systems may have common subsystems or components. The HV provide better fue ...n a second electric motor) to either recharge the battery or directly feed power to an electric motor that drives the vehicle. This contrasts with all-[[Bat
    64 KB (9,873 words) - 22:35, 14 June 2009
  • ...n at any given time, thus ensuring the most efficient use of the available power and torque. ...on mechanism of the rest of the Delta range, but in this application it is power-assisted. Steering effort has been reduced further by fitting thrust bearin
    34 KB (4,989 words) - 17:46, 6 November 2012
  • ...on, long seddle, crouching handlebar and several engine modifications with power increment up to 1hp. ...orks in oil bath . The pump command is derived from a coxial cam to put on auxiliary gear shaft. Usefull the centrifugal oil filter, pity that it is mounted in
    23 KB (3,832 words) - 09:44, 14 April 2011
  • ...and that the 1.5 litre supercharged engine was a dead end: Any increase in power meant more fuel to carry or more time lost in the pits for refuelling, For {{F1|1966}} saw a 'Return to Power' as Formula One changed the engine rules once again, allowing engines of 3.
    67 KB (10,614 words) - 08:56, 7 October 2009
  • Since cyclists' legs produce a limited amount of power most efficiently over a narrow range of ''[[Cadence (cycling)|cadences]]'', ...lanetary, or epicyclic, gearing]], in which the outer case of the hub gear unit turns at a different speed relative to the rear axle depending on which gea
    53 KB (8,173 words) - 09:32, 25 September 2009