Search results

Jump to navigation Jump to search
  • ...alled a "'''[[Balbo]]'''". The aircraft went on to serve the [[Italian Air Force]] and the [[Luftwaffe]] in [[World War II]] as a long range [[bomber]] and
    3 KB (368 words) - 08:04, 4 August 2009
  • ...estimates that dynamic braking provides between 50% to 70% of the braking force during blended braking.
    4 KB (648 words) - 21:47, 26 September 2009
  • ...g triangles, telescopic shocks-absorber and coaxial cylindrical motivating force. Rear suspension to inferior oscillating trapezes, advanced cross-sectional ...inal struts, telescopic shocks-absorber and coaxial cylindrical motivating force. Motor front Fiat 1,200. Bore 68mm, run 75mm. Piston displacement 1,089 cm3
    6 KB (758 words) - 20:07, 16 February 2015
  • ...the outbreak of [[World War I]], Georges Boillot joined the new French Air Force. He lost his life on April 21, 1916 when his plane was shot down in a dogfi
    3 KB (425 words) - 11:09, 15 June 2009
  • ...World War One, with the extensive use of his unique designs in Italian Air Force aircraft. He also developed and manufactured the engines for the celebrated ...ine was used on the Atlantic flights in 1931 and 1933 when the Italian Air Force was planning air routes to the Americas.
    4 KB (623 words) - 22:41, 11 June 2013
  • ...ld, which can then be used in a frontal collision to spread out the impact force over time. ...the back of the seats. It makes it easier for the suspension to absorb the force of bumps so the riders feel a smoother ride. But in sports cars this benef
    6 KB (975 words) - 14:43, 24 September 2009
  • ...ansion of the [[anti-lock braking system]], designed to distribute braking force during emergency braking whilst cornering. CBC interacts with ABS to counte
    2 KB (241 words) - 23:12, 15 November 2009
  • ...ine relies entirely on the piston's motion to draw in fuel and air, and to force out the exhaust gasses. As the piston descends on the intake (inlet) stroke ...rce is lost through the exhaust port that could be driving the piston, the force that the piston must exert on the gasses to exhaust them from the cylinder
    12 KB (1,944 words) - 22:56, 14 June 2009
  • ...es through the vertical plane of the tire, rather than through a [[shear]] force across it. On the other hand, for maximum straight-line acceleration, obvio
    3 KB (491 words) - 10:10, 2 August 2009
  • * On a long train the brake force during a brake application was not consistent along the length of the train ...ol valve set the rate of change of brake force, not the level of the brake force).
    7 KB (1,061 words) - 09:12, 7 October 2009
  • ...t can be seen that longer con rods will reduce the amount of this sideways force, and therefore lead to longer engine life. However, for a given engine bloc
    7 KB (1,108 words) - 06:53, 18 April 2009
  • |Trigger force || 5.5 to 7.28 lbf (24 to 32 N) ...s]] and is planned for distribution to the [[U. S. Army]], the [[U. S. Air Force]], the [[U. S. Navy]], and the [[United States Coast Guard|U. S. Coast Guar
    7 KB (965 words) - 22:32, 22 September 2009
  • ...The full official title of the force is '''''Arma dei Carabinieri''''' (''Force of Carabinieri''). ...y|Army]], [[Marina Militare|Navy]] and [[Aeronautica Militare Italiana|Air Force]]), thus ending their long standing as the first corps (''Arma'') of the Ar
    14 KB (1,953 words) - 17:55, 28 February 2009
  • ...ˈgwardja di fiˈnantsa/}}) is an [[Italian police|Italian military police]] force under the authority of the Minister of Economy and Finance. It is a part of ...orps’ configuration as a military structure, enhanced its role as a police force having general competence on all economic, financial and judicial matters f
    6 KB (914 words) - 10:25, 14 June 2009
  • ...ndency for otherwise [[Elasticity|elastic]] materials to rebound with less force than was required to deform them. Simple vehicles with no separate shock a ...easily rebuilt with simple hand tools. A disadvantage is that the damping force tends not to increase with the speed of the vertical motion.
    9 KB (1,376 words) - 22:53, 15 August 2009
  • ...w#Bolt|bolts]] exerting compression well into the 14 [[MPa]] (2000 [[pound-force per square inch|psi]]) range or higher. Generally speaking, there are sever
    2 KB (289 words) - 11:07, 8 October 2009
  • ...tore energy and subsequently release it, to absorb shock, or to maintain a force between contacting surfaces. They are made of an [[elastic]] material form
    2 KB (330 words) - 17:24, 12 March 2010
  • ...either to change the [[volume]] enclosed by the cylinder, or to exert a [[force]] on a [[fluid]] inside the cylinder.
    2 KB (354 words) - 08:11, 8 October 2009
  • ...oth the [[Italian Social Republic]] and the [[co-belligerent]] Italian air force.
    3 KB (469 words) - 10:24, 14 June 2009
  • ...of the tire is moving at double the speed of the car, and aerodynamic drag force varies with the [[Square_number|square]] of the speed). The visibility of t
    3 KB (496 words) - 09:28, 14 June 2009
  • ...of the tire is moving at double the speed of the car, and aerodynamic drag force varies with the [[Square_number|square]] of the speed). The visibility of t
    3 KB (498 words) - 23:20, 23 September 2009
  • ...(mechanics)|transmission]] gears can adjust the amount of [[torque]] or [[force]] vs. [[speed]] in much the same way an electrical transformer adjusts [[vo
    3 KB (470 words) - 09:34, 21 September 2009
  • === Force India ===<!--since 2008--> * [[Vijay Mallya]] - [[Force India]] co-owner
    9 KB (1,255 words) - 13:56, 19 March 2009
  • ...cyclists (or bikers) prefer the winter rallies, such as the Mayflower MCCs Force Ten rally or the Dean Vally MCCs Rallymans Rally. The usual order of the da
    3 KB (576 words) - 16:18, 13 June 2009
  • ...ver 1.1 [[g-force|G]] in cornering, some drivers have measured a cornering force of 1.4 G, which remains an excellent performance figure.
    5 KB (641 words) - 19:35, 27 October 2009
  • ...aluminium]] block, protected by a [[carbon fiber]] casing. The [[g-force|G-Force-Meter]] is completely new and it is one of the talking points of the Revent ...he usual circular instruments; [[speedometer]] and [[tachometer]]. The [[G-Force]]-Meter still remains at the center of this display mode.
    6 KB (950 words) - 19:39, 21 October 2009
  • ...nded [[Eton College]] in England. He served in the [[British]] [[Royal Air Force]] in [[World War I]]. He was shot twice, but lived, in separate incidents i
    4 KB (606 words) - 09:34, 21 September 2009
  • ...se the rotation of the drum drags the shoes around with it, increasing the force holding them together. This can be used to make a very powerful brake (as
    4 KB (592 words) - 14:12, 4 August 2009
  • ...g would be infeasible if a liquid were used as the mode of transmission of force, as it is in [[hydraulic brakes]]. In addition, the use of an air brake sys ...the "cut-out" level (no higher than 130 lbs. per square inch, or "[[Pound-force per square inch|p.s.i.]]" or 896 [[Pa|kPa]]), the governor stops the compre
    26 KB (4,530 words) - 21:58, 17 August 2009
  • !align="left" valign="top"|Labour force !align="left" valign="top"|Labour force by occupation
    15 KB (2,062 words) - 12:58, 18 September 2009
  • ...eering effort (especially on vehicles without [[power steering]]) but more force applied to the steering components by road surface imperfections, braking,
    3 KB (429 words) - 14:44, 12 November 2009
  • | [[Panoz|G-Force]] | [[Panoz|G-Force]]
    9 KB (1,126 words) - 22:14, 19 July 2009
  • ...- accelerating [[force]] is applied to the rear wheels, on which the down force increases, due to [[load transfer]] in acceleration, making the rear tires
    9 KB (1,331 words) - 08:17, 18 August 2009
  • ...elf-servo effect and the braking force is always proportional to the pedal force being applied by the driver. ...can take high heat usually do best when hot and will have reduced braking force when cold. Also, high heat pads typically have more aggressive compounds a
    14 KB (2,301 words) - 09:07, 18 September 2009
  • ...sure above the car will apply a downward force. Naturally, to maximize the force one wants the maximum area at the minimal pressure. Racing car designers ha ...d effects. If this occurs in a corner where the driver is relying on this force to stay on the track, its sudden removal can cause the car to abruptly lose
    10 KB (1,581 words) - 22:18, 14 September 2010
  • ...wnward force, requiring the main wing to produce more lift to balance this force, and thus increasing [[induced drag]]. The Avanti's aerodynamics and turbop
    5 KB (732 words) - 11:07, 8 October 2009
  • *[[Force India F1|Force India]] |rowspan=2| {{flagiconIndia}} [[Force India F1|Force India F1 Team]]
    16 KB (2,102 words) - 00:52, 6 February 2011
  • ...ler is like a wedge and bearing loads tend to try to eject the roller; the force from the collar which keeps the roller in the bearing adds to bearing frict ...load. Smaller rolling elements are lighter and thus have less centrifugal force, but smaller elements also bend more sharply where they contact the race, c
    13 KB (2,121 words) - 07:16, 6 July 2009
  • ...- accelerating [[force]] is applied to the rear wheels, on which the down force increases, due to [[load transfer]] in acceleration, making the rear tires
    9 KB (1,427 words) - 23:37, 20 September 2009
  • ...lications in [[automobile]]s and [[light truck]]s. It is used to transfer force under pressure from where it is created through [[hydraulic]] lines to the
    3 KB (431 words) - 14:32, 27 October 2014
  • ...[[1970 | seventies]] by Rosario Di Blasi, a former pilot of' [[Italian Air Force]]. Appreciated expert flying technique, is the inventor of the "[[Ruler for
    4 KB (627 words) - 11:01, 29 March 2009
  • These all turn out to be winning choices. The labor force produces excellent bicycles, while the team led by [[Edoardo Pavesi]], the
    4 KB (671 words) - 12:50, 26 December 2008
  • .... It is a quadruple apex corner with a load of 5[[G-force|G]] (5 times the force of gravity) for 4 seconds. It is actually 4 corners joined together. Many d
    7 KB (866 words) - 22:07, 4 November 2009
  • | [[Panoz|G-Force]]
    4 KB (547 words) - 08:51, 9 August 2009
  • ...t its axis, either by way of gravity or by application of another external force. Common examples are found in [[transport]] applications. More generally th ...enables efficient movement of an object across a surface where there is a force pressing the object to the surface. Common examples are a cart drawn by a h
    13 KB (1,944 words) - 12:16, 8 October 2009
  • ...liquid]] under [[pressure]], the fracture of a [[solid]] from an applied [[force]], or the vibration of an ear in response to [[sound]]. A practitioner of
    10 KB (1,246 words) - 09:54, 26 October 2009
  • ...g|motorcycle]] [[road racing|road racer]]. In the 1950s, he was a dominant force in the smaller classes of [[Grand Prix motorcycle racing]].
    5 KB (676 words) - 23:50, 20 September 2009
  • During [[World War II]] he served in the [[Royal Australian Air Force]]. In [[1946]] he opened a small repair business. He also raced midget cars
    4 KB (611 words) - 19:37, 8 March 2009
  • ...r bicycles, braking on these bikes is still achieved only by reversing the force on the pedals. This is not a disadvantage for the very specialized manner i ...several types of '''rim brakes'''. In all of these designs, the braking [[force]] is applied by the rider squeezing a [[lever]] mounted on the [[handlebar]
    26 KB (4,406 words) - 08:46, 12 September 2009
  • ...corners. The differential is designed to drive a pair of wheels with equal force, while allowing them to rotate at different speeds. In vehicles without a d ...f a differential is that it can reduce overall [[torque]] - the rotational force which propels the vehicle. The amount of torque required to propel the vehi
    12 KB (1,976 words) - 09:04, 8 October 2009

View (previous 50 | next 50) (20 | 50 | 100 | 250 | 500)