Search results

Page title matches

• Sway bar
  ...gether through short [[lever]] arms linked by a [[torsion spring]]. A sway bar increases the suspension's roll stiffness -- its resistance to roll in turn ...tiffness to be tuned for different situations without replacing the entire bar.
  5 KB (793 words) - 09:26, 7 October 2009

Page text matches

• Sway bar
  ...gether through short [[lever]] arms linked by a [[torsion spring]]. A sway bar increases the suspension's roll stiffness -- its resistance to roll in turn ...tiffness to be tuned for different situations without replacing the entire bar.
  5 KB (793 words) - 09:26, 7 October 2009
• Panhard rod
  A '''Panhard rod''' or '''track bar''' is a component of a [[automobile|car]] [[suspension (vehicle)|suspension ...le to the car body or [[chassis]] on the opposite side of the vehicle. The bar is attached on either end with pivots that permit it to swivel upwards and
  2 KB (340 words) - 21:48, 26 September 2009
• Boost gauge
  ...ure pressure in either [[pound-force per square inch|psi]] or [[bar (unit)|bar]] and many also measure manifold [[vacuum]] also in.Hg
  1 KB (231 words) - 08:43, 8 October 2009
• Torsion beam suspension
  [[Image:Torsion Bar.gif|thumb|right|250px]] ...Torsion (mechanics)|torsion]] resistance. The effective spring rate of the bar is determined by its length, diameter, and material.
  6 KB (962 words) - 10:46, 8 October 2009
• Independent suspension
  ...r independent suspension on an [[Four-wheel drive|AWD]] car. The anti-roll bar has some orange paint on it.]] ...be connected with anti-roll bars or other such mechanisms. The anti-roll bar ties the left and right suspension spring rates together but does not tie t
  3 KB (389 words) - 01:08, 7 December 2010
• Twin-turbo
  ...around seven bar [[gauge pressure]] (101 psi) are common and as high as 10 bar (145psi) in some cases. ...the inlet of the second turbocharger and nine bar absolute pressure (eight bar gauge) at the inlet manifold of the engine. The pressure ratio in this exam
  6 KB (973 words) - 22:07, 2 June 2010
• Gaggia
  ...ffee]] machine on September 5, 1938, to be used commercially in his coffee bar. The machine forced water to flow over the coffee grounds at a high pressur
  1 KB (159 words) - 12:02, 8 October 2009
• LaMonza Motorsport Country Club
  ...e foot club house complete with the Grand Prix Restaurant, and the Daytona Bar & Lounge. Other amenities will include private on-site garage condo’s, re
  1 KB (163 words) - 22:25, 6 October 2009
• Taurus
  ...es]] with overhead [[camshaft]], some with a rear [[suspension]] [[torsion bar]].
  1 KB (197 words) - 14:02, 27 November 2016
• Automotive terms Italian to English
  | Torsion bar | Anti-roll bar (sway bar)
  5 KB (629 words) - 10:22, 6 December 2012
• Wishbone suspension
  In front view the suspension is a 4 bar link, and it is easy to work out the camber gain (see [[camber angle]]) etc *[[Strut bar]]
  4 KB (613 words) - 10:46, 8 October 2009
• Alfa Romeo Tipo 512
  |Front suspension || wishbones, longitudinal torsion bar, friction dampers, hydraulic shock absorbers |Rear suspension || [[De Dion tube|De-Dion-axle]], longitudinal torsion bar, friction dampers, telescopic shock absorbers
  3 KB (430 words) - 11:09, 26 April 2010
• 2003 Monaco Grand Prix
  | [[British American Racing|BAR]]-[[Honda]] | '''[[British American Racing|BAR]]-[[Honda]]'''
  4 KB (425 words) - 12:04, 25 September 2009
• Minardi M198
  | double wishbones, pushrod with coaxial spring/damper and torsion bar | double wishbones, pushrod with coaxial spring/damper and torsion bar
  6 KB (779 words) - 09:08, 23 April 2010
• Racing setup
  | Front [[sway bar]] || softer || stiffer | Rear sway bar || stiffer || softer
  4 KB (670 words) - 19:51, 27 September 2009
• Caffè
  ...quickly, often with the elbow of the arm holding the glass resting on the bar counter, it may also be enjoyed for the duration of the afternoon, which is
  6 KB (1,097 words) - 11:04, 8 October 2009
• Bandini formula junior
  ...is a novelty, the solution to independent multilink rear wheels with anti-bar and telescopic hydraulic shock absorbers and springs elicoidal cylindrical ** Front: Independent, triangles overlapping with stabilizing bar, [[camber]] recordable
  6 KB (869 words) - 11:39, 24 December 2016
• Nassetti
  ...motor, but is still related to a [[bicycle]]. E.g. by assembling a handle-bar, and long cranks, so when you have a brake-down, you always can cycle. Beli ...pretty, for you can see clearly that the Dilly line has grown. The handle-bar has vanished and the frame is unique. A tube-frame at the front and a steel
  7 KB (1,072 words) - 22:34, 18 April 2010
• 1999 Formula One season
  ! rowspan=3 | [[British American Racing|BAR]] | rowspan=3 | [[BAR 001|001]]
  32 KB (3,769 words) - 22:46, 7 February 2011
• 2003 Formula One season
  | rowspan=3 | {{flagiconUK}} [[Lucky Strike]] BAR Honda ! rowspan=3 | [[British American Racing|BAR]]
  66 KB (8,595 words) - 00:47, 6 February 2011
• 2000 Formula One season
  ...n="2"| {{flagiconUK}} [[Lucky Strike]] [[Reynard]] British American Racing BAR Honda !rowspan="2"| [[British American Racing|BAR]]
  32 KB (3,831 words) - 22:46, 7 February 2011
• Smeg
  ...don’t generally come cheap (with a fridge-freezer currently around £1000), bar the low-end “contract” ranges which are generally only used for new bui
  3 KB (500 words) - 12:01, 8 October 2009
• Compression ratio
  :<math> p_{TDC} = (1 bar) \times 10^{1.4} = 25.1 bar</math> ...essure for common automotive designs should at least equal 10 [[bar (unit)|bar]], or, roughly estimated in [[pounds per square inch]] (psi) as between 15
  16 KB (2,479 words) - 14:53, 25 September 2009
• Watt's linkage
  ...nd behind the rear axle, where they attach to the ends of a short vertical bar whose center is mounted to the center of the axle and which is free to rota
  3 KB (582 words) - 09:31, 7 October 2009
• Multi-link suspension
  ...use of multi-link suspension use in desert racing, the use of a good sway bar is needed to counter body roll.
  3 KB (519 words) - 16:52, 26 October 2009
• Car tuning
  ...s handling response. Other components that are sometimes added are [[strut bar]]s, which improve the body stiffness and help better maintain the proper su
  8 KB (1,297 words) - 19:20, 26 April 2010
• Fiat Coupé
  ...iling arms mounted on an auxiliary subframe, coil springs and an anti-roll bar.
  7 KB (1,086 words) - 10:35, 2 November 2009
• Fiat Coupe
  ...iling arms mounted on an auxiliary subframe, coil springs and an anti-roll bar.
  7 KB (1,086 words) - 06:08, 26 September 2016
• Maserati Shamal
  The center pillar acts as a roll bar and is always finished in black, a distinguishing characteristic of the Sha
  4 KB (514 words) - 23:17, 27 August 2010
• Suspension (vehicle)
  ...ly for use in Roll Couple calculations. "Bump" wheel rate of the Anti-Roll Bar is calculated by moving 1 wheel 1 inch with the other end fixed. But, Roll ...s and deflection on the actual springs but not the forces on the Anti-Roll Bar.)
  29 KB (4,645 words) - 10:46, 8 October 2009
• 2002 Formula One season
  | rowspan=2 | {{flagiconUK}} [[Lucky Strike]] BAR Honda ! rowspan=2 | [[British American Racing|BAR]]
  49 KB (6,224 words) - 09:08, 7 October 2009
• 2004 Formula One season
  ...ari]] Marlboro. Also notable were the success of [[British American Racing|BAR]] and [[Renault F1|Renault]], as well as the poor performance of [[Williams ...th [[Japan|Japanese]] team mate [[Takuma Sato]], [[British American Racing|BAR]] impressed by finishing second behind Ferrari.
  72 KB (8,875 words) - 00:48, 6 February 2011
• Michael Doohan
  ...was the use of a hand-operated rear brake, which he operated by a "nudge" bar on the left [[handlebar]]. Some commentators have argued that this techniq
  4 KB (651 words) - 19:51, 27 September 2009
• Alfa Romeo GT
  ...el drive ruote, quadri-lateral with double oscillating bar and stabilizing bar articulated on ball joints ...m, reaction joints, helical coil over dampers, and articulated stabilizing bar on ball joints, linked to the shock absorbers.
  10 KB (1,482 words) - 18:14, 26 October 2009
• Fiat Barchetta
  The '''Fiat Barchetta''' (pronounced "bar-KET-ta") is a [[roadster]] produced by the [[Italy|Italian]] manufacturer [
  5 KB (648 words) - 10:04, 2 November 2009
• Units of measurement
  ...ndard. One metre is the same length regardless of temperature, but a metal bar will be one metre long only at a certain temperature.
  12 KB (1,936 words) - 17:54, 7 July 2011
• ASA
  At the 1966 Geneva Motorshow ASA showed the 'Roll-Bar' or 613 RB. This had a tubular chassis and plastic/composite bodyshell. It ...way bar. Up front, twin wishbones were controlled by coil springs and sway bar---conventional, Ferrari type stuff. But the ASA also had four wheel disc br
  15 KB (2,470 words) - 10:59, 13 April 2012
• 2005 Formula One season
  ...ing 2004 season the most conspicuous drop in performance after Ferrari was BAR-Honda who were barred from two races due to regulations infractions. Thanks ...us teams. They were the [[Sauber]], [[Minardi]], [[British American Racing|BAR]] and the [[Jordan Grand Prix|Jordan]] team. Meanwhile, this was [[Rubens
  74 KB (9,233 words) - 00:49, 6 February 2011
• V10 Centauro
  ...Rider ergonomics are poor due to its awkward seating position: the handle bar is flat, straight and mounted a bit too low, and its footpegs are too high
  4 KB (642 words) - 10:12, 2 April 2010
• Mika Salo
  Following an injury to [[British American Racing|BAR]] driver [[Ricardo Zonta]], Salo did get a short-term drive for 1999, for t ! [[British American Racing|BAR]] [[BAR 01|01]]
  24 KB (3,349 words) - 10:07, 2 April 2010
• California II
  ...akes vs. single, floorboards vs. pegs, tube vs. tubeless tires, and handle-bar configurations. * 2003 California Titanium Special Sport: small fairing, lower bar and less chrome than Aluminum, titanium gray.
  17 KB (2,259 words) - 08:42, 8 October 2009
• 2001 Formula One season
  | rowspan=2 | {{flagiconUK}} [[Lucky Strike]] BAR Honda ! rowspan=2 | [[British American Racing|BAR]]
  54 KB (6,811 words) - 22:45, 7 February 2011
• Bandini-Maserati 1500
  ...ic telescopic tilted and [[spring | springs]] cylindrical helical coaxial; bar Account
  5 KB (630 words) - 20:37, 19 December 2009
• Farina
  ...ly remarkable car, the Javelin, which featured a 1500cc flat four, torsion-bar springing all round - independent at the front, live axle at the rear with ...rina's Jupiter 2.jpg|thumb|200px|right|Flat four, tubular chassis, torsion bar suspension. The Jupiter was well designed and miles ahead of its time.]]
  10 KB (1,604 words) - 15:27, 12 October 2009
• Top dead center
  ...by hand. In large engines the flywheel is moved with a lever or "turning bar". Both operations must be done with care to avoid the operator becoming ent
  5 KB (842 words) - 21:57, 25 May 2010
• Minardi M01
  | Double wishbones, pushrod with coaxial spring/damper and torsion bar
  7 KB (849 words) - 09:09, 23 April 2010
• Monocoque
  *[[Strut_bar|Strut Bar]]
  5 KB (829 words) - 10:46, 8 October 2009
• Freestyle Motocross
  *Star Fish (Extended Bar Hop) *Candy Bar
  11 KB (1,647 words) - 20:12, 19 October 2010
• Ljubljana
  ...ll Irish Pubs. Big Screen TVs show sporting events, (mainly football) but bar staff are happy to change a television to show other sports (Rugby Union, R ...yone with any interest in wine should visit here. The cosy, candlelit wine bar comes with knowledgeable barmen who can recommend a wine based on your tast
  18 KB (2,941 words) - 09:24, 7 October 2009
• Aprilia SR50
  ...ng the variator (gears), restricting the carburettor, placing a restrictor bar across the bottom of the [[engine]] (to stop the installation of racing exh
  6 KB (835 words) - 17:06, 4 March 2010

View (previous 50 | next 50) (20 | 50 | 100 | 250 | 500)