Search results
Jump to navigation
Jump to search
- ...head and was chain driven. The [[motorcycle]] had a system with a partial gears, a two-stroke engine, with air suction in the crankcase where the intake ai1 KB (172 words) - 02:39, 6 January 2011
- ...valves per cylinder) driven by a [[cam]] side (in the basement) driven by gears, drive shaft supports 4; [[compression ratio]] 4.8 : 1, maximum power [[Cav ...p with command over reverse-stick side; final report of reduction (conical gears) 2722:1 (18/49)4 KB (489 words) - 20:23, 24 February 2009
- ...V 49 cc [[mopeds]], which were delivered Roll-up drives, but also with two gears and a chain drive. MAV (2) is possibly a continuation of this company.1 KB (148 words) - 07:55, 17 April 2010
- ...engine was transmitted via a [[transmission]] chain and by the means of [[gears]], the force then led from there to a drive wheel. This model, however, did1 KB (172 words) - 02:11, 26 April 2011
- ...oduction concentrated on a small [[Invicta]], a 6/8hp (two-cylinder, three gears and chain drive) versions and a 10/12 hp (two four-cylinder blocks Three ge1 KB (172 words) - 09:13, 14 October 2011
- ...s where the rotating axis' of the two lie on an angle - 90deg for example) gears and a shaft running on the outside of the engine block. Then at around 1973 KB (485 words) - 23:55, 15 November 2009
- ...was not. A drum on the rear axle was driven positively by a belt. Changing gears were not done by pulleys, as was usual for a belt drive, it used a drum wit1 KB (205 words) - 23:57, 1 November 2010
- 4 gears top speed 85 km/h<br>1 KB (197 words) - 15:55, 14 December 2010
- ...d a power magnet that was for the timing. Parallelogram fork, two separate gears, a primary and secondary transmission chain; the chain was right by the ped1 KB (197 words) - 01:29, 29 December 2010
- 3 gears top speed 75 km/h<br>2 KB (214 words) - 16:38, 14 December 2010
- ...structed several [[mopeds]]: the ''Vulture'' 125 cc, two stroke with three gears and the Centaur Gran Sport, with a two-stroke engine, 160 cc and the upgrad1 KB (212 words) - 00:02, 18 December 2016
- ..., which turns the entire carrier (all blue), providing torque to both side gears (red and yellow), which in turn may drive the left and right wheels. If the ...the same direction as the ring gear, but ''within'' that motion, the side gears can counter-rotate relative to each other.12 KB (1,976 words) - 09:04, 8 October 2009
- ...ission synchronizers]] (in the 1920s) and [[Gear#Helical_gears|helical cut gears]], double clutching was a technique required to prevent damage to an [[auto ...btaining a commercial driver license, many experienced truckers will float gears or slip shift, thus eliminating the clutch except for starting and stopping6 KB (1,014 words) - 08:51, 1 October 2009
- ...nd used the mark for their first bike that had a 3.5 hp engine and a three gears [[transmission]]. In 1932 the name ''Wolsit'' reappeared on a bicycle with2 KB (245 words) - 19:09, 21 June 2016
- |Transmission || 2 gears2 KB (213 words) - 11:21, 18 December 2016
- ...tically as the vehicle moves, thus freeing the driver from having to shift gears [[manual transmission|manually]]. (Similar but larger devices are also used ...the steering column or on the floor next to the driver. In order to select gears/modes the driver must push a button in (called the shift lock button) or pu18 KB (2,740 words) - 23:27, 3 July 2009
- ...al (for the time) ''Batu'', a bike with a 120cc [[two-stroke engine]], two gears and an open frame.4 KB (668 words) - 10:16, 25 June 2016
- ...a King SaSa drive model for the [[camshaft]] which was driven by beveled [[gears]] and sapling. In 1954 came the last change to the block. The sump was chan2 KB (272 words) - 10:06, 28 November 2010
- | Gears ||3 KB (323 words) - 16:56, 10 March 2009
- ...roke 250 cc and 350 cc [[engine]], transmission gearbox was a 4-speed with gears mounted on ball bearings and a transmission belt. The rigid frame that crad2 KB (258 words) - 12:40, 1 July 2010