Search results
Jump to navigation
Jump to search
- ...xicab|taxi]] and [[police]] fleets, due to cheaper maintenance, and in the case of police fleets, better performance. ...plied to the rear wheels, on which the down force increases, due to [[load transfer]] in acceleration, making the rear tires better able to take simultaneous a9 KB (1,331 words) - 08:17, 18 August 2009
- ...xicab|taxi]] and [[police]] fleets, due to cheaper maintenance, and in the case of police fleets, better performance. ...plied to the rear wheels, on which the down force increases, due to [[load transfer]] in acceleration, making the rear tires better able to take simultaneous a9 KB (1,427 words) - 23:37, 20 September 2009
- ...ake]] applications in [[automobile]]s and [[light truck]]s. It is used to transfer force under pressure from where it is created through [[hydraulic]] lines t ...sibility of brake fluid will increase pedal feel (firmness), but in either case this effect is minimal. The US Army has used silicone brake fluid exclusive3 KB (431 words) - 14:32, 27 October 2014
- ...g|thumb|right|224px|The [[Jeep Wrangler]] is a 4WD vehicle with a transfer case to select low range or high range 4WD.]] ...igned primarily for heavy off-road use, normally with a low range transfer case (e.g. a [[Toyota Land Cruiser]]). The terms are thus quite vague in modern22 KB (3,431 words) - 14:39, 24 September 2009
- This method of scavenging uses carefully aimed transfer ports to loop fresh mixture up one side of the cylinder and down the other In a cross flow engine the transfer ports and exhaust ports are on opposite sides of the cylinder and a baffle15 KB (2,394 words) - 23:48, 11 September 2009
- ...ation must be taken with some non-independent suspension designs. Take the case of the straight axle. When viewed from the front or rear, the wheel rate ca ...ith a Roll Couple Percentage of 70% will transfer 70% of its Sprung Weight Transfer at the front of the vehicle during cornering.29 KB (4,645 words) - 10:46, 8 October 2009
- This method of scavenging uses carefully aimed transfer ports to loop fresh mixture up one side of the cylinder and down the other In a cross flow engine the transfer ports and exhaust ports are on opposite sides of the cylinder and a baffle19 KB (3,049 words) - 09:48, 2 August 2009
- When the rate of energy transfer or work is constant, all of this can be simplified to ...umed to be unity, and can therefore be omitted from the equation. In this case, the effective and apparent power are assumed to be equal.8 KB (1,393 words) - 12:16, 8 October 2009
- # Supporting heat transfer from the piston to the cylinder wall. ...2mm long from the point of maximum wear to the point of zero wear. In this case there is not actually any ridge to hit, so light honing may be all that is6 KB (1,010 words) - 09:55, 25 September 2009
- ...g|thumb|right|224px|The [[Jeep Wrangler]] is a 4WD vehicle with a transfer case to select low range or high range 4WD.]] ...V]] Sahara. Unlike other 4x4 vehicles which use a conventional [[transfer case]] to drive the front and rear axle, the Sahara had two engines, each indepe18 KB (2,913 words) - 08:51, 18 March 2006
- ...xicab|taxi]] and [[police]] fleets, due to cheaper maintenance, and in the case of police fleets, better performance. ...r, as more of the engine can lie between the front and rear wheels (in the case of a [[mid engine]] layout, the entire engine), and the transmission is mov9 KB (1,374 words) - 10:51, 8 October 2009
- ...sion, coupled with a "2wd high, 4wd high, 4wd low" Newprocess 229 transfer case.5 KB (790 words) - 13:54, 10 December 2009
- ...aforza]] for the US and European markets was a 4WD vehicle with a transfer case to select low range or high range 4WD.]] ...t shafts, causing all wheels to turn at the same rate, providing torque in case of slippage. This is generally used for the center differential, which dis35 KB (5,226 words) - 17:47, 27 September 2009
- ...I & C. Sas "el'officina closed the offices of Milan, via Della Torre 24 to transfer the head office again in Milan, Piazza San Babila 4 / A and production at i ...fixed together, gives the motor a Spartan look which vever used to be the case.7 KB (1,072 words) - 22:34, 18 April 2010
- ...th the foundation of BPCC (National Bank of Rural District Gerace) and the transfer of [[Court]]. ...unications]] for the Railway. Also, was inserted between the workshops, in case of war, were mobilized for the construction of [[aircraft engine]].7 KB (1,040 words) - 22:35, 11 October 2011
- ...is known as the "dual-compartment reservoir”. Normal service applications transfer air pressure from the service portion to the brake cylinder, while emergenc ...itiated emergency application) or near the break in the train line (in the case of the train line coming apart). Farther away from the source of the emerge20 KB (3,254 words) - 23:06, 5 July 2009
- ...eer]]. Releasing the throttle pitches the car forward, causing a [[weight transfer]] towards the front of the car, thus reducing rear traction even further. ...er condition to rotate the car around a corner, but this isn't usually the case for two reasons. Accelerating early as the car passes the [[Apex (racing)|8 KB (1,387 words) - 09:32, 7 October 2009
- ...relative to the track, determines [[load transfer]], also called [[weight transfer]], from side to side and causes body lean. Centrifugal force acts at the c The center of gravity height, relative to the wheelbase, determines load transfer between front and rear. The car's momentum acts at its center of gravity t36 KB (5,845 words) - 08:04, 8 October 2009
- ...nding multi-cylinder piston engine, in three dimensions the reverse is the case. As well as the rotor apex seals evident in the conceptual diagram, the rot ...arge surface area of the combustion chamber which reperesents a large heat transfer and quench area, combined with an unfavorably long rather thin stretched co10 KB (1,627 words) - 08:32, 2 October 2009