Search results

...earings can support both [[radial]] ([[perpendicular]] to the shaft) and [[axial]] loads ([[parallel (geometry)|parallel]] to the shaft). For lightly-loade ...ity than ball bearings, but a low axial capacity and higher friction under axial loads. If the inner and outer races are misaligned, the bearing capacity o

...n designs and configurations which are required to carry radial as well as axial thrusts.

...t the use of reduced-voltage high beam [[headlamps]] producing up to 7,000 axial [[candela]], as well as permitting any light color from [[white]] to [[ambe ...use, DOT proposed changes to the DRL specification that would have capped axial intensity at 1,500 candela, a level nearly identical to the European 1,200

...provide a 15mm lower centre of gravity while a particularly advanced multi-axial carbon floorpan is 50% lighter than before and also increases rigidity. Per

...This layout gives superior scavenging, as gas flow through the cylinder is axial rather than radial, and simplifies design of the piston crowns. In the Jumo

*Multi stage axial flow *Axial turbine

*Solid state, tapered chain shock absorbers, using one or more tapered, axial alignment(s) of [[granular]] spheres, typically made of metals such as [[ni

...iron with micro-alloy. Two banks of three cylinders are arranged at a 15° axial angle from the crankshaft. The cylinder bores are 81 mm in diameter wi

...n used on [[Power take-off|PTO]]-powered agricultural equipment, since the axial PTO shaft is at odds with the usual need for the driven shaft, which is eit