Search results

• Ducati Bronco
  |Top speed || 53 mph |Transmission || 4 speed [[Manual transmission|manual]]. Gear ratios: I 1:2.69, II 1:1.85, III 1.36
  6 KB (888 words) - 21:25, 9 November 2010
• Terra Modena
  engineer Piero Ferrari and the technicians of High Performance Engineering of Modena. The lubrication consists of system. It is made of aeronautical GAlsi 9 aluminum, not steel. This frame enables “trajectory precision even at
  6 KB (940 words) - 09:05, 12 November 2016
• Bandini formula junior
  ...aterial]]: frame of elliptical and circle section tubes, [[steel]] special steel aeronautics derivation ; * Top speed: 210 km / h
  6 KB (869 words) - 11:39, 24 December 2016
• Alfa Romeo Junior
  ...109 hp, with 103 lb./ft torque low in the rev range. Combined with a five-speed gearbox and Alfa Romeo's sweet chassis with four-wheel disc brakes, it was ...o's two-seat coupe body weighed 182 lb. less than the stock Giulia GT. Top speed increased to 118 mph, but that does not tell the whole story. The car was m
  5 KB (729 words) - 07:41, 22 June 2016
• Two-stroke cycle
  ...many combustions per second as a four-stroke engine revolving at the same speed). Two-stroke engines often have a simple lubrication system in which oil is ...o been used in [[diesel engine]]s, notably [[opposed piston]] designs, low speed units such as large marine engines, and [[V8]] engines for trucks and heavy
  19 KB (3,049 words) - 09:48, 2 August 2009
• Car safety
  Despite technological advances, the death toll of car accidents remains high: about 40,000 people die every year in the US. While this number increases ...dy found a significantly lower risk of serious injury in silver cars; with high risks for brown, black, and green cars. (Furness ''et al'', 2003).
  14 KB (2,148 words) - 11:11, 7 July 2009
• Passive safety
  Despite technological advances, the death toll of car accidents remains high: about 40,000 people die every year in the US. While this number increases ...dy found a significantly lower risk of serious injury in silver cars; with high risks for brown, black, and green cars. (Furness ''et al'', 2003).
  14 KB (2,151 words) - 17:35, 7 August 2009
• Shock absorber
  ...ubber]] disks, [[stretching]] of rubber bands and cords, [[bending]] of [[steel]] [[spring (device)|spring]]s, or twisting of [[torsion spring|torsion bar] .... A disadvantage is that the damping force tends not to increase with the speed of the vertical motion.
  9 KB (1,376 words) - 22:53, 15 August 2009
• Ferrari F50
  Crankshaft: Forged steel<br> Exhaust Manifold: Stainless steel<br>
  9 KB (1,292 words) - 00:20, 14 October 2009
• Sports car racing
  ...1930s, most Grand Prix cars like the [[Silver Arrows]] were optimised for high performance in their relative short races, by dropping fenders and the seco ...Endurance Championship]] (or [[World Sportscar Championship]]), featuring high-tech closed-cockpit prototypes from [[Porsche]], [[Aston Martin]], [[Merced
  8 KB (1,293 words) - 14:15, 24 September 2009
• Graphite-reinforced plastic
  ...ufacture composites has hitherto limited their use in applications where a high number of complicated parts is required. ...bly is most widely used in the "safety cell" monocoque chassis assembly of high-performance race cars.
  12 KB (1,819 words) - 19:04, 14 November 2010
• Itom
  ...ith tubular frame and automatic clutch; this was soon followed with a two-speed version. 1953 - introduction of the Esperia, which had a 2 speed gearbox and a pressed steel monocoche (Italian: monoscocca) frame.
  6 KB (961 words) - 20:32, 22 November 2010
• Ducati Monster
  | Transmission || 6-speed ...odromic valve]] engines (also known as a '''90° [[V-Twin]]''') and tubular steel trellis chassis, both features designed by the late [[Fabio Taglioni]] ([[1
  5 KB (735 words) - 10:27, 26 October 2009
• Turbo-Hydramatic
  ...1980s]] onward, it was progressively replaced by later four-speed and five-speed automatics (which incorporate an overdrive gear), some of which continue to ...lutch to provide second gear reaction, the TH400 is able to withstand very high torque input. As a result, it met with considerable success in commercial
  14 KB (2,205 words) - 17:10, 11 May 2009
• Dirt speedway racing
  ...cal and regional racetracks throughout the nation: some estimates range as high as 1500. The sport is popular in Australia and Canada also. Many of the car ...vy block with stroker crank, high flow degreed aluminum cylinder heads and high-flow exhaust headers. Engines are capable of 750 hp (560 kW) and redline at
  13 KB (2,197 words) - 09:41, 8 October 2009
• Ollearo
  |Maximum speed || 90 kilometers per hour, average 65 km per hour ...ket saturated with other brands and needed to present a business plan at a high technical level, to attract the attention of "afficionados" and obtain cons
  6 KB (881 words) - 19:11, 25 June 2018
• Bandini formula 3
  * Structure and [[material]]: frame of elliptical section tubes, special [[steel]] aeronautics derivation; patent No. 499843 * [[Exchange (mechanical) |Gearbox]] and clutch: 4 speed+ RG, clutch single dry disc
  6 KB (916 words) - 11:24, 13 February 2009
• Fiat 8V
  | Transmission || 4 and 5-speed manual ...rd form giving a top speed of 190 km/h. The engine was connected to a four speed gearbox. The car had independent suspension all round and drum brakes on al
  13 KB (2,069 words) - 07:01, 1 May 2012
• Lancia 037
  ...ual shock absorbers in the rear in order to cope with the stresses of high speed off road driving. The 037 is notable as it retained the rear wheel drive l
  4 KB (677 words) - 11:04, 18 October 2009
• Lancia Lambda
  * '''5th series''', produced 1925, 1,050 built. 4-speed gearbox. *Four-speed manual transmission
  7 KB (999 words) - 15:29, 6 December 2010

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)